TPA3132D2 – Einschaltverzögerung und Schnellabschaltung (Anti-POP) – auch für TPA3116 / TPA3118
Wem die Einschaltverzögerung von 10ms (TPA3132D2, TPA3116D2, TPA3118D2) nicht ausreicht (z.B. bei Verwendung größerer Zeitkonstanten/Koppel-Kondensatoren) und auch etwas gegen den “Ausschalt-Plop” tun möchte, kann sich mit 2 Komparatoren und einigen passiven Bauelementen weiterhelfen.
Dual-Komparator
Die Schaltung funktioniert im Bereich 10-26V, verzögert MUTE beim Einschalten und sorgt für eine Schnellabschaltung via SDZ bei fehlender Betriebsspannung.
Die Verzögerungszeit (MUTE high) wird mit C29 gesetzt, 1uF ~200ms. Die Betriebszustände zeigen die folgenden Diagramme:
R C D
Bewährt hat sich in der Praxis folgende Minimalvariante bestehend aus Widerstand & Kondensator als Zeitkonstante und einer Diode zu Schnellabschaltung.
Hola
Me gustaría instalar el circuito y estoy buscando el diodo Schottky cuyo valor (tipo)
Aquí es adecuado cualquier diodo Schottky que pueda soportar al menos 10V.
Hice el procedimiento y fue capaz de detener el ruido cuando se enciende la tarjeta, junto con eso resuelto el problema de la sobrecarga cuando se recubre el amplificador con alto volumen sería encender y apagar, pero no podía eliminar el ruido de cuando apagarlo, que menos inconveniente, ya que es más suave. No modificar o insertar cualquier resistencia, me acaba de agregar un condensador 10uF en el amplificador amp del estéreo y un condensador 33uF en el IC de la subwofer. Los valores son diferentes para evitar que los dos se conectan entre sí y dar una posible sobrecarga en la fuente.
Hola,
but the nominal of R26 is not written
Sorry for that, i’d recommend the “R C D” circuit, it is proven to work.
Yes, but it is does not avoid a pop after shout dawn
Did you tested it like shown? It actually works fine here on the TPA3132D2 boards. (Even on a hard shut down/power loss)
Is SDZ connected to FAULTZ?
Hallo!
I have 5.1 Amplifier on 4 TPA3116D2, there’s POP problem on shut-down.
All mute inputs are linked together .
Does your schematic will work on it?
P.S. As i figured out in my amplifier combined mute line connected to 10K resistor (on the ground) and non-polar electrolite 2.2uF (i suppose, to VGDD). But this native solution works crappy :(.