30W LED strobe - portable "The Dizzler"

Stroboscope in your Pocket? Bring it! The following "product", the "Dizzler" was resurrected with minimal use of materials.

Were used:

  • 30W LED (warm white, 10s3p 32V 1A 2700 lumens)
  • XL6009 Step-Up (400 kHz 4A)
  • 555 timer PCB with adjustable frequency/duty cycle
  • Inverter for 555 output (transistor 2 resistors)
  • NTC fan controller from ATX power supply
  • Enclosure Hammond 1554E
  • 40x40mm fan (Delta Inc.
  • 30W LED (warm white 10s3p) 32V 1A
  • 3 x 18650 battery holders
  • 3 x Samsung ICR18650-22FM (measured 2030mAh Notebook battery)
  • N 30V-FET IRLR7843 VDS, ID 113A, RDS 3.3mR, QG 33nC

The output of the 555 goes to an NPN transistor (as an inverter), 10 k at base, 1 k 5 between VCC and collector, emitter on Earth. On the collector worn the gate of the FET used as a low-side switch for the LED on the secondary side of the transformer. Converters and LED share a heatsink, Flash rate currently adjustable from 0.5 - 75 Hz. The duty cycle was elected with 0.15, the LED will pulse power fired with approximately 39V, CA 2.8A - should be more than 2700 lumen luminous flux.
IMG_7437

IMG_7435

IMG_7422

AGML battery charger

You may so like...

4 responses

  1. Russ says:

    Pretty cool. Any possibility to get a schematic for “The Dizzler”?

  2. Stefano Torricini says:

    How can I "The Dizzler" order?

    • 360customs says:

      Not at all because only remains self-made.

      30W LED
      Boost-Converter
      3s 18650 Li-Ion cell holders + cells or 3s LiPopack
      counter
      casing
      You may
      PWM-Generatorboard

  1. 30 November 2014

    […] […]

Leave a Reply to Russ Cancel reply

Your email address will not be published.

* Checkbox GDPR is required,,en,This form collects your name, email and content so that we can keep track of the comments placed on the website. For more info check our privacy policy where you'll get more info on where, how and why we store your data.,,en,I agree,,en

*

I agree